Monday, August 25, 2014

Flaring and Swaging Tool

To connect the AC soft copper pipe can be done in two ways: the connection can be off again (wear double neple) and connection by using welding. These devices are also called flaring and swaging ie increase the diameter of the pipe end with a slope of 450, for the purpose of flaring is that the two pieces of pipe of the same diameter can reconnect with neple.

How to Use Flaring and Swaging
I. Using Flaring
Ie developing pipe end with a slope typically is used if you want to connect pipes on outdoor and indoor air-conditioning, connection with the use of this flaring connection manually by using double neple.
1 loosen the butterfly nut and open the clamp block the pipeline ready for grip, adjust the diameter of the pipe with a clamp block
2 Pinch the pipe to be in flaring on the block with a size of 2-3 mm height above the surface of the block clamp and tighten the butterfly nut block
3 Put the flaring eyes right in the middle of the diameter of the pipe, turn the handle clockwise suppressor slowly, doing up the pipe widens and the slope of the slope of the pipe until it touches the clamp block.

II. using Swaging
This tool is to make the diameter of the pipe ends to be larger so that the pipes of the same size can be plugged in and in need of welding machines to dial. how to use these tools are not much different from using only a change of flaring his eyes flaring swaging saja.sesuaikan eye with copper pipe that will be in swaging

Before connecting ac pipes is done make sure the connection is good there is no leakage at the connection manually or by using the welding machine connections, if the connection is using the flaring is not in nepelnya tighten firmly on the automatic air conditioning is not cold because freonnya out (leaked), and also at the time of welding pipe has been in swaging sure welding wire (silver) has been fused with copper pipes.

No comments:

Post a Comment